Filter
Top Products
Maintenance Instructions LUBRICATION
36
3. Remove the dipstick and oil drain plug, and drain
oil into a suitable container. Be sure to allow
ample time for complete drainage.
4. Before removing the oil filter, clean the area
around the filter to keep dirt and debris out of the
engine.
5. Remove the old oil filter and wipe off the filter
mounting surface on the engine.
Dipstick and Oil Fill
(view from above left side of tractor)
Oil Drain and Oil Filter Locations
(view from above right side of tractor)
6. Apply a thin coating of new oil to the rubber gas-
ket on the replacement oil filter.
IMPORTANT: Use ONLY oil filters from the
engine manufacturer. Aftermarket oil filters may
not seal properly and/or may not have the cor-
rect pressure relief valve for proper lubrication.
7. Install the new oil filter on the engine. Turn the
oil filter clockwise until the rubber gasket con-
tacts the sealing surface, then tighten the filter
an additional 1/2 to 3/4 turn.
8. Reinstall the drain plug.
9. Fill the crankcase with new, clean oil. Use only
crankcase lubricants recommended by the
engine manufacturer. Refer to Specifications in
this manual or the engine owner’s manual. Use
the recommended oil viscosity for the expected
ambient temperature. Oil with the correct
viscosity will aid starting in cold weather and
assure proper lubrication in hot weather. Fill to
FULL mark on the dipstick; crankcase capacity
is 1.9 quarts (1.8 liters) when changing oil and
filter.
IMPORTANT: Check the dipstick reading be-
fore pouring in the last 1/2 pint of oil and fill only
to the FULL mark. The oil level should never be
over the FULL mark on the dipstick; overfilling
can result in engine overheating and loss of
power.
10. Start the engine and check for oil leaks around
the oil filter. Stop the engine, recheck the oil lev-
el, and add oil if necessary. (When the engine
is first operated with a new oil filter, the oil level
will drop slightly as the filter is filled with oil.)
Oil Fill/
Dipstick
Oil Filter
Oil Drain