Filter
Top Products
28 se c t i O n 7— se r v i c e
Rolling the Belt onto the PTO Pulley.
Using the deck lift handle, raise the deck to the position
that provides the most horizontal run of the belt between
the engine.
Make certain the belt is in the spindle pulleys of the deck, 2.
and that the backside of the belt is against both the fixed
and movable idler pulleys. Refer to Fig. 7-3.
Sitting behind the tractor, facing forward, make certain the 3.
belt is not twisted; then reach beneath the tractor to grasp
Use caution to avoid pinching your
While holding the belt and pulley together, rotate the 5.
rotating the pulley and belt until the belt is fully rolled into
Replacing the Deck Drive Belt
Remove the deck from beneath the tractor, (refer to Deck
Remove the hex tapping screws securing the belt covers 2.
to the deck and remove the belt from the spindle pulleys.
Install the new belt around the spindle pulleys as shown in 3.
Route the belt rearward between the two idler pulleys
and reinstall the deck following the instructions in Deck
Installation on page 30.
Deck Installation
To install the mower deck, proceed as follows:
While holding the deck front hanger rod upward, carefully
slide the deck underneath the right side of the tractor.
While still holding the front hanger rod, slide the deck 2.
forward until the front hanger rod can be lowered into the
slots of the front deck bracket.
Lower the front hanger rod into the slots of the front deck 3.
bracket, then slide the deck rearward.
Maneuver the deck so that the slots in the two rear deck
hanger brackets approximately align with the deck lift arms
of the tractor. Refer to Fig. 7-5.
Use the tractor deck lift handle to lower the deck lift arms 5.
into the slots of the rear deck hanger brackets.
as necessary to align the holes in the deck lift arms with the
pins. Refer to Fig. 7-5.
When aligned, push each pin fully inward through the lift 7.
arms to secure the arms in the rear hanger bracket slots.
8.
deck; then route the belt rearward beneath the tractor
the bottom of the engine.
following two methods.
The muffler at the rear of the tractor
may be extremely hot, and could cause serious
burns. Use extreme caution when near the muffler.
Allow the muffler to fully cool before installing the
belt.
Using the Idler Pulley to Tension the Belt.
Using the deck lift handle, raise the deck to the position
that provides the most horizontal run of the belt between
the engine.
2.
engine.
Route the backside of the belt around the fixed idler pulley 3.
of the deck. Refer to Fig. 7-3.
Working from the middle of the tractor, pivot the idler
bracket/movable pulley rearward against the spring
tension and slide the backside of the belt onto the movable
idler pulley. Refer to Fig. 7-3.