12
7. Reinstall the air filter
cover. Position the
slots on the top of the
air filter cover onto the
tabs at the top of the
back plate (Fig. 30).
8. Swing the cover down
until the tab on the air
filter backplate snaps
into place in the slot
on the air filter cover
(Fig. 31).
CARBURETOR ADJUSTMENT
The idle speed of the engine is adjustable. An idle adjustment
screw is between the air
filter cover and the engine
starter housing (Fig. 32).
NOTE: Careless
adjustments can
seriously damage
your unit. A
qualified service
dealer should
make carburetor
adjustments.
Check Fuel
Old fuel is usually the
reason for improper unit performance. Drain and refill the tank
with fresh fuel prior to making any adjustments. Refer to Oil
and Fuel Information.
Clean Air Filter
The condition of the air filter is important to the operation of
the unit. A dirty air filter will restrict air flow. This is often
mistaken for an out of adjustment carburetor. Check the
condition of the air filter before adjusting the idle speed screw.
Refer to Air Filter Maintenance.
MAINTENANCE AND REPAIR INSTRUCTIONS
NOTE: Use the bottle and spout saved from initial use to
measure the correct amount of oil. The top of the label
on the bottle measures approximately 3.04 ounces (90
ml) or 3/8 cup (Fig. 25). Check the level, See Checking
the Oil Level. If the level is low, add a small amount of
oil and recheck. Do not overfill (Fig. 25).
6. Replace the oil fill plug.
7. Reconnect the spark plug boot.
AIR FILTER MAINTENANCE
Cleaning the Air Filter
Clean and re-oil the air filter every 10 hours of operation. It is an
important item to maintain. Failure to maintain your air filter
properly can result in poor performance or can cause
permanent damage to your engine.
1. Open the air filter cover. Push the tab on the under side of the
cover inward. Then pull the air filter cover out and up from the
bottom of the cover (Fig. 26).
2. Remove the air filter (Fig. 26).
3. Wash the filter in detergent and water (Fig. 27). Rinse the
filter thoroughly and allow it to
dry.
4. Apply enough clean SAE 30
motor oil to lightly coat the filter
(Fig. 28).
5. Squeeze the filter to spread and
remove excess oil (Fig. 29).
6. Replace the filter (Fig. 26).
NOTE: If the unit is operated
without the air filter, you will
VOID the warranty.
Fill Level
Fig. 25
WARNING: To avoid serious personal injury,
always turn the unit off and allow it to cool before
you clean or service it.
Fig. 27
Fig. 28
Fig. 29
Fig. 30
Locking Tab
Tabs
Back Plate
Air Filter
Air Filter Cover
Air Filter
Tab
Fig. 31
Air Filter Cover
Air Filter
Tab
Fig. 26
Idle Adjustment Screw
Fig. 32