Filter
Top Products
9Section 2 — ASSembly & Set-Up
Connecting Extension Cord
NOTE: Do not plug your extension cord into the power source
receptacle (outlet) prior to routing it through the cord retainer
and connecting the extension cord to the snow thrower’s power
cable.
To properly route your extension cord through the strain reliever:
1. Approximately 14 to 16 inches from its end, crease your
extension cord to form a tight loop.
2. Push the loop through the bottom hole in the strain
reliever.
3. Position the loop over the clips found on the strain reliever
and pull down until the cord fits snugly into the clip. See
Fig. 3-10.
NOTE: Use a UL-approved extension cord. A 100-foot,
14-gauge cord is recommended. A 50-foot, 16-gauge
cord is acceptable. Refer to the small chart found in Safe
Operation Practices.
NOTE: The strain reliever reduces strain on the extension
cord so that it does not come unplugged during operation.
4. Plug the snow thrower power cable into the extension
cord. See Fig. 3-10.
5. Install the chute in the auger housing with the handle
facing towards the rear of the snow thrower. See Fig. 3-8.
6. Re-install the front cover with the four screws removed in
step 1. See Fig. 3-9.
Side View
Figure 3-8
Screw
Front Cover
Chute Assembly
Figure 3-9
Figure 3-10