Filter
Top Products
Assembly & Set-Up
3
7
NOTE: All references to the left and right side of the snow
thrower are from the operator’s position behind the snow
thrower.
Tools Required for Assembly
• Phillips Head Screwdriver
Unpacking the Unit
1. Cut the corners of the carton and lay the sides flat on the
ground. Remove all packing inserts.
2. Lift the upper handle and mid handle up and off the snow
thrower. See Fig. 3-1.
3. Make certain the carton has been completely emptied
before discarding it.
Handle Assembly
1. Install the strain reliever on the mid handle. See Fig. 3-2.
NOTE: The flared area on the lower portion of the mid
handle must face forward throughout the assembly.
2. Attach the upper handle to the mid handle using one
carriage screw and handle knob on each side. See Fig. 3-3.
NOTE: Make sure the cord is routed behind the handle
assembly.
Contents of Carton
• One Electric Snow Thrower • One Upper Handle • One Mid Handle
• One Chute Assembly • One Electric Snow Thrower
Operator’s Manual
• One Product Registration Card
Figure 3-1
Figure 3-2
Carriage Bolt
Carriage Bolt
Handle Knobs
Figure 3-3