Filter
Top Products
Service
7
14
WARNING: Unplug the snow thrower and remove
the key to avoid unintended starting before
servicing the snow thrower.
Replacing Skid Plate
1. Remove the three screws securing the skid plate to the
auger housing. See Fig. 7-1.
2. Remove the worn skid plate and replace with a factory
approved skid plate.
3. Secure using the three screws removed earlier.
Replacing Auger Belt
1. Unscrew the six screws securing the belt cover to the auger
housing and remove the belt cover. See Fig. 7-2.
2. Pull the idler bracket upward to relieve tension on the belt.
See Fig. 7-3.
CAUTION: Do not unhook the idler extension
spring. Doing so may allow the spring to become
dislodged and lost in the auger housing.
3. Pull the belt off Pulley B.
4. Replace in the opposite order.
Pulley A
Idler Bracket
Pulley B
Figure 7-3
Figure 7-2
Side View
Figure 7-1