Filter
Top Products
If replacing the entire assembly, put the new friction 6.
wheel assembly in place and follow the steps in reverse to
re-assemble. If you only want to replace the friction wheel
rubber continue with step 7.
Remove the four screws from the friction wheel assembly. 7.
See Fig. 7-11.
Remove the friction wheel rubber from between the 8.
friction wheel plates.
Reassemble new friction wheel rubber to the friction wheel 9.
plates and hub, tightening the four screws in rotation and
with equal force (between 6 ft.-lbs. and 9 ft.-lbs.).
Position the friction wheel assembly up onto the pin of 10.
the shift rod assembly, and slide the shaft through the
assembly. See Fig. 7-9. Reassemble in reverse order.
Screws
Side Plates
Rubber Ring
Figure 7-11
26 se c t i O n 8— se r v i c e