Filter
Top Products
8
Attaching the Shift Cable
8. Place the shift lever in the forward position. Insert the
end of the shift cable into the hole in shift lever
located on the underside the handle panel.
9. Position the shift cable’s threaded adjuster in the slot
found on the shift lever mount bracket. (one nut below
the mount bracket and the flat washer, lock washer
and second nut above the mount bracket. See Inset).
10. Adjust the shift cable as follows:
a. Using a ½” wrench, thread the bottom nut
upward until the cable is taut.
b. Using a ½” wrench, thread the top nut
downward to secure the adjuster to the mount
bracket.
Position the shift cable (and three other cables)
against the left handle tube. Secure them to the
handle with the cable tie provided as shown in the
illustration at the top of the page.
Gas and Oil Fill-up
Gasoline
Service the engine with gasoline as instructed in the
separate Briggs & Stratton Operator/Owner Manual
packed with your tiller. Read instructions carefully.
Oil
IMPORTANT:
Pour the entire contents of the provided oil
bottle into the engine’s oil fill.
8
9
A
B
10