Filter
Top Products
Finish securing chute control assembly to chute support 3.
bracket with wing nut and hex screw removed earlier.
Check that all cables are properly routed through the cable
guide on top of the engine. See Fig. 3-5.
Figure 3-4
Set-Up
Shear Pins
A pair of replacement auger shear pins and bow tie cotter pins
are included with your snow thrower. Store them in your snow
Chute Clean-Out Tool
The chute clean-out tool is fastened to the top of the auger
housing with a mounting clip and a cable tie at the factory. Cut
the cable tie before operating the snow thrower. See Fig. 3-7.
Figure 3-6
Chute Clean-out Tool
Figure 3-7
Figure 3-5
8 se c t i O n 3— as s e M b l y & se t-up