Troy-Bilt 2620 Snow Blower User Manual


  Open as PDF
of 60
 
Assembly
Handle

2.
both cables are aligned with roller guides before pivoting

NOTE: Make certain the upper ends of each cable are
seated properly in its bracket.
Secure the handle by tightening the plastic knob located 3.
on both the left and right sides of the handle. Remove
and discard any rubber bands, if present. They are for
packaging purposes only.
Chute Assembly
Remove wing nut and hex screw from chute control 
assembly and clevis pin and cotter pin from chute support

the chute base. See Fig. 3-2.
2.
control assembly to chute support bracket with clevis pin
and cotter pin removed earlier. See See Fig. 3-3.
Figure 3-3
Contents of Carton
  

Manual
Figure 3-1
Figure 3-2
Assembly & Set-Up
3
7
 previous next