Filter
Top Products
Adjustments
Skid Shoes
The snow thrower skid shoes are adjusted upward at the factory
for shipping purposes. Adjust them downward, if desired, prior
to operating the snow thrower.
CAUTION: It is not recommended that you operate
this snow thrower on gravel as it can easily pick up
and throw loose gravel, causing personal injury or
damage to the snow thrower and surrounding
property.
For close snow removal on a smooth surface, raise skid
shoes higher on the auger housing.
Use a middle or lower position when the area to be cleared
is uneven, such as a gravel driveway
NOTE: If you choose to operate the snow thrower on a gravel
surface, keep the skid shoes in position for maximum clearance
between the ground and the shave plate.
To adjust the skid shoes:
Loosen the four hex nuts (two on each side) and carriage bolts.
Make certain the entire bottom surface of skid shoe is 2.
against the ground to avoid uneven wear on the skid shoes.
Retighten nuts and bolts securely.3.
Chute Assembly
The distance snow is thrown can be adjusted by changing the
angle of the chute assembly. To do so:
Stop the engine by removing the ignition key and loosen the
plastic knob found on the left side of the chute assembly.
2.
the wing knob.
Auger Control
WARNING!
carefully read and follow all instructions below.
is operating safely and properly.
Check the adjustment of the auger control as follows:
When the auger control is released and in the disengaged
In a well-ventilated area, start the snow thrower engine. 2.
throttle is set in the FAST position.
While standing in the operator’s position (behind the snow 3.
thrower), engage the auger.
Allow the auger to remain engaged for approximately ten
several times.
With the throttle control in the FAST (rabbit) position and 5.
the front of the machine.
Confirm that the auger has completely stopped rotating
signs of rotating, immediately return to the operator’s
position and shut off the engine. Wait for ALL moving parts
to stop before re-adjusting the auger control.
To readjust the control cable, loosen the upper hex nut on 7.
8.
downward to increase cable tension).
Retighten the upper hex nut.
been achieved.
Figure 3-11
Figure 3-10
10 se c t i O n 3— as s e M b l y & se t-up