Filter
Top Products
15
Figure 17
• Pull the brake bracket assembly towards the cable
guide roller and unhook the auger cable “Z” fitting.
• Remove the upper bolts and lock washers which
secure the auger housing assembly to the frame
assembly using a 9/16” wrench.
• Separate the auger housing from the frame
assembly by tilting the housing forward and pulling
up the handles.
• Using a 1/2” wrench, remove the hex screw and
bell washer from the center of the pulley on the
auger housing. Lift the brake bracket assembly out
of the pulley groove and remove the pulley. Be
careful not to lose the key. See Figure 20.
• Remove and replace auger belt inside belt keepers.
• Reassemble pulley to auger housing with hex
screw and bell washer (cupped side toward the
pulley). Make sure key is in place on shaft and
brake puck is seated in the pulley groove.
• Reassemble the belt cover and chute directional
control.
Proper Adjustment: With the auger clutch lever in the
disengaged position the top surface of the new belt
should be even with the outside diameter of the pulley.
• To adjust, disconnect ferrule from brake bracket
assembly and thread ferrule in (towards idler) to
increase tension on belt, and out to decrease tension.
NOTE: The brake puck must always be firmly seated in
the pulley groove when the auger control is in the
disengaged position.
Drive Belt
• Unhook the extension spring from the belt cover
plate. See Figure 21.
• Remove drive belt from the engine pulley and
bottom drive pulley. Refer to Figure 21
Figure 18
Figure 19
Figure 20
• Replace belt and reassemble in reverse order.
Upper Bolt
(remove)
Hairpin
Clip
Flat
Belt Cover
Belt Cover Bolts(3)
Shoulder Bolt
(do not remove)
Washers
Engine Pulley
Shoulder Bolt
Ferrule
Engine
Pulley
Auger Idler
Rod
Auger Control
Belt
Brake Bracket
Assembly
Z Fitting
Cable Roller
Guide
Brake Bracket Assembly
Auger Belt
Hex Screw &
Bell Washer
Belt Keepers
Auger Pulley
Idler Pulley