Filter
Top Products
18
Note: You can use your personal computer and the Toro
Scheduling Advisor interactive software to guide you
through the complete watering schedule process. When
the schedule is ready, simply transfer it to the ECXTRA
with the Time Pod–and it’s ready to run.
It is always helpful to plan your watering schedule on
paper before beginning the programming steps. You
will have a record of your watering schedule and zone
locations which can be kept with your ECXTRA after it is
installed. If you have an indoor model timer, a watering
schedule form is provided on page 20 for you to fill out
then remove to keep with the timer. This form is duplicat-
ed on a decal located on the inside cover of the outdoor
model timer.
Guidelines for Watering
There are several factors to be considered when decid-
ing when and how long to water. For example, the soil
type (i.e., clay, loam, etc.), the part of the landscape
being watered, climate conditions and the type of sprin-
klers being used. Because of these variables, we cannot
provide an exact schedule to follow, but here are some
general watering guidelines to help you get started.
• Water early in the morning, one to two hours before
sunrise. You will have the best water pressure at this
time and the water can soak into the plant root zone
while evaporation is minimal. Watering during mid-day
or in the evening may cause plant damage or mildew.
• Watch for signs of under- or over-watering and make
program adjustments immediately.
Filling Out the Watering Schedule Form
When filling out this form, use a pencil so changes
can be easily made. After installing the indoor model
timer, remove the form and store it in the pocket formed
between the mounting bracket and the back of the timer
housing. Refer to the example form shown on the oppo-
site page and fill out your form in a similar manner with
the following information:
•
Location - Identify the location of each watering zone
and the type of plant being watered.
Note: Enter the following information for each pro-
gram. If the program is not needed, leave its informa-
tion column blank.
•
Watering Day Schedule - For a Calendar schedule,
circle day(s) of the week watering is desired. For an
Interval schedule circle the desired Interval number.
For Odd or Even days, simply mark the appropriate
box. If you need to restrict watering on certain days,
circle the Exclude day(s).
•
Zone Run Time - Indicate the amount of run time
(1 minute to 4 hours) for each zone. Write “Off” for any
zone which you do not want to operate in the program.
•
Program Start Times - Indicate the time of day to
start the program. Each program can have 1 to 4 start
times per watering day.
Note: A start time that occurs while a watering
cycle is in progress will be delayed until the
current watering cycle is finished. Therefore, when
using multiple start times within a program or when
using multiple programs, schedule the start times to
allow each watering cycle to run completely before the
next cycle starts.
Planning Your Watering Schedule