Filter
Top Products
WARNING
Incorrectly installing the blades could damage
the machine or cause an injury to the operator
or to bystanders.
Washing Underneath the
Machine
Service Interval: Before each use or daily—Wash
underneath the machine.
1. Move the machine to a level surface.
2. Stop the engine and wait for all moving parts to stop
before leaving the operating position.
3. Lower the machine to the lowest height-of-cut.
4. Attach a hose to the washout tting, and turn the
water on high (
Figure 48).
Note: Spread petroleum jelly on the washout tting
O-ring to make the coupling slide on easier and
protect the O-ring.
Figure 48
1. Washout tting 3. O-ring
2. Hose
4. Coupling
5. Start the engine, engage the blade-control lever, and
let the machine run for 1 to 3 minutes.
6. Disengage the blade-control lever, stop the engine,
and wait for all moving parts to stop.
7. Shut off the water and remove the coupling from
the washout tting.
Note: If the machine is not clean after a single
washing, soak it and let it stand for 30 minutes. Then
repeat the process.
8. Run the machine again and engage the blades for 1
to 3 minutes to remove the excess water.
WARNING
A broken or missing washout tting could
expose you and others to thrown objects or blade
contact. Contact with a blade or thrown debris
can cause injury or death.
• Replace a broken or missing washout tting
immediately, before using the machine
again.
• Never put your hands or feet under the
machine or through openings in the mower.
24