Filter
Top Products
1
2
3
4
5
6
7
G017635
Figure 15
Rear cutting-height lever
1. 1 inch (2.5 cm) 5. 3 inches (7.6 cm))
2. 1-1/2 inches (3.8 cm) 6. 3-1/2 inches (8.9 cm))
3. 2 inches (5.1 cm) 7. 4 inches (10.2 cm)
4. 2-1/2 inches (6.4 cm)
Adjusting the Handle Height
You can raise or lower the handle to a position more
comfortable for you.
1. Pull the handle-lock lever rearward to disengage the
handle-lock pins (
Figure 16).
2
G016488
3
1
Figure 16
1. Handle-lock lever 3. Notches
2. Handle-lock pin (2)
2. Rotate the handle and align the desired notch in
the handle bracket to the handle-lock pins; refer to
Figure 16.
3. Release the handle-lock lever to secure the handle
in place.
Starting the Engine
Standard Model
Pull the recoil handle slowly until you feel resistance,
then pull it sharply. Allow the rope to return to the
engine slowly.
Note: If the machine does not start after several
attempts, contact an Authorized Service Dealer.
Electric-start Model
You can start the engine on an electric-start model by
using either the ignition key or the recoil-start handle.
• Ignition Key: Turn and hold the ignition key to the
Start position (Figure 17); when the engine starts,
release the key.
Important: Do not attempt to start the engine
with the blade-control bar engaged; otherwise,
you may blow the fuse.
10