Filter
Top Products
Assembly Section 2-3
ASSEMBLY
HEATER LINE MODIFICATION (CAB UNITS)
Some later modles require heater line modifications. Drain the anti-freeze from
the tractor. Find the two short heater hoses located on the outside lower front corner
of the cab. Follow these hard lines under the tractor motor to the oil pan and label
each line the same on both ends. Remove the short hoses and cut these hard lines
at the center of the oil pan. Replace these lines with longer heater hose. Route
these hoses back to the lower front corner of the cab avoiding any sharp edges. See
the pictures below. Be sure to double hose clamp the end nearest the oil pan.
Caution these heater lines are polarized and must be hooked up to the same way
as in the beginning. See the pictures below.
12-10-01
ADJUSTING REAR WHEELS
Raise rear of tractor onto jack-stands and adjust tires / rims all the way out.
Follow the instructions in the tractor owners manual for adjusting tires and
rims. NOTE: This may require switching the wheels to opposite sides of tractor.
Do not reinstall wheels onto tractor until valve has been mounted (cab), and all hoses
have been installed