Filter
Top Products
Assembly Section 2-17
ASSEMBLY
SELECTOR VALVE INSTALLATION
The selector valve is attached to the boom rest as noted above. The 1/4” hoses
from the swivel section of the lift valve are plumbed to the “A” and “B” ports on the
selector valve. A run tee is added to the return section of the lift valve. Attach the 1/2”
hose from the “T” port of the selector valve to the run tee as shown in the parts section.
1/4” hoses are attached to the “A1”, ”A2”, “B1” & “B2” ports on the selector valve to the
knuckle cylinder and swivel cylider(as shown below and in the parts section.)
SELECTOR VALVE RELOCATION
Drill a set of Ø3/8” or Ø10MM holes 1-1/2” to the right of the existing holes on the
Leagal Rear Stow Boomrest. Install the selector valve using the hardware provided
as shown in the parts section of this manual.