Filter
Top Products
Operation Section 4-13
OPERATION
RBF-2C 07/04
© 2004 Alamo Group Inc.
FLAIL HEAD INSPECTION
¾ Inspect blades and blade bolts for looseness and
excessive wear. Rotate to 90° to make for checking
easier. Replace damaged, worn, and missing
blades as complete sets to maintain cuttershaft
balance.
¾ Ensure rubber deflectors are in position and not
damaged. Replace worn, broken, and missing
sections immediately.
¾ Ensure the rollers are in good condition and rotate
freely.
¾ Inspect that all bolts and screws are in position
and are properly torqued.
¾ Ensure hydraulic lines are properly connected to
the hydraulic motor. Check for hydraulic leaks along
hoses and fittings. DO NOT use your hands to
check for oil leaks. Use a piece of heavy paper or
cardboard to check for hydraulic oil leaks.
¾ Inspect the condition of the drive belts.
¾ Ensure the drive belt shields are in place and in
good repair.
¾ Remove any grass or other debris which may be
wrapped around the cuttershafts ends.
¾ Inspect the condition of deck skid shoes and
hardware.
WARNING!
Do not put hands or feet under mower decks. Blade Contact can result
serious injury or even death. Stay away until all motion has stopped and
the decks are securely blocked up. (SGM-9)