Filter
Top Products
Safety Section 1-14
SAFETY
RBF-2C 07-04
© 2004 Alamo Group Inc.
WARNING!
Never attempt to lubricate, adjust, or remove material from the
Implement while it is in motion or while tractor engine is running. Make
sure the tractor engine is off before working on the Implement.
(SG-20)
DANGER!
Never work under the Implement, the framework, or
any lifted component unless the Implement is
securely supported or blocked up to prevent sudden
or inadvertent falling which could cause serious
injury or even death. (SG-14)
DANGER!
Do Not fill gasoline tank while engine is running. Refuel only after
engine has cooled down. If gasoline is spilled, move machine away
from the area of the spill and avoid creating any source of ignition
until the gasoline has evaporated.
(SG-28)
WARNING!
Perform service, repairs and lubrication according to the maintenance section. Ensure the unit
is properly lubricated as specified in the lubrication schedule and all bolts and nuts are properly
torqued. Failure to properly service, repair and maintain this Implement in good operating
condition could cause component failure and possible serious injury or even death. (SG-35)
WARNING!
Use caution and wear protective gloves when handling sharp objects such as blades, knives,
and other cutting edges. Be alert to worn component surfaces which have sharp edges. Sharp
surfaces can inflict severe laceration injuries if proper hand protection is not worn. (SG-37)
DANGER!
Replace bent or broken blade with new blades. NEVER ATTEMPT TO STRAIGHTEN OR
WELD ON BLADES SINCE THIS WILL LIKELY CRACK OR OTHERWISE DAMAGE THE
BLADE WITH SUBSEQUENT FAILURE AND POSSIBLE SERIOUS INJURY FROM THROWN
BLADES. (SGM-10)
WARNING!
DO NOT weld or repair rotating mower components. Welds and other repairs may cause severe
vibration and/or component failure resulting in parts being thrown from the mower causing
serious bodily injury. See your Authorized Dealer for proper repairs. (SGM-13)
PARTS INFORMATION
Tiger mowers use balanced and matched system components for blade carriers, blades, cuttershafts, knives,
knife hangers, rollers, drivetrain components, and bearings. These parts are made and tested to Tiger
specifications. Non-genuine "will fit" parts do not consistently meet these specifications. The use of “will fit”
parts may reduce mower performance, void mower warranties, and present a safety hazard. Use genuine Tiger
mower parts for economy and safety.
(SPTM-1)
SEE YOUR TIGER DEALER