Filter
Top Products
Assembly Section 3-9
RBF - 2C 07-04
ASSEMBLY
© 2004 Alamo Group Inc.
FIGURE 3-7
FITTING ROTOR UNIT
The rotor unit can now be fitted to the end of the arms. Illustration shows the Rhino 1948 cowl bracket.
A. Start tractor engine.
B. Raise second arm so that the mower head clamp is approximately 300mm (18 in) clear of the ground.
C. Place mower head directly in front of the second arm.
D. Level up mower head with wood packing.
E. Remove clamp bracket FIGURE 3-7 (A) from the end of arms.
F. Adjust position of the arms until the mower head clamp is lined up with the clamping bar on top of the
rotor unit in the desired position along the bar. (See FIGURE 3-7).
G. Replace clamp bracket FIGURE 3-7 (A) and nut and washers FIGURE 3-7 (B). Tighten fully.