Filter
Top Products
Safety Section 1-11
SAFETY
RBC - 19C 07-04
© 2004 Alamo Group Inc.
DANGER!
The rotating parts of this machine have been designed and tested for rugged use. However,
they could fail upon impact with heavy, solid objects such as steel guard rails and concrete
abutments. Such impact could cause the broken objects to be thrown outward at very high
velocities. To reduce the possibility of property damage, serious injury, or even death, never
allow the cutting blades to contact such obstacles. (SGM-4)
WARNING!
Many varied objects, such as wire, cable, rope, or chains, can become entangled in the operating
parts of the mower head. These items could then swing outside the housing at greater velocities
than the blades. Such a situation is extremely hazardous and could result in serious injury or even
death. Inspect the cutting area for such objects before mowing. Remove any like object from the
site. Never allow the cutting blades to contact such items. (SGM-6)
WARNING! Mow at the speed that you can safely operate and control the tractor and mower. Safe mowing
speed depends on terrain condition and grass type, density, and height of cut. Normal ground speed
range is from 0 to 5 mph. Use slow mowing speeds when operating on or near steep slopes, ditches,
drop-offs, overhead obstructions, power lines, or when debris and foreign objects are to be avoided.
(SGM-7)
WARNING!
Avoid mowing in reverse direction when possible. Check to make sure there are no persons are
behind the mower and use extreme care when mowing in reverse. Mow only at a slow ground speed
where you can safely operate and control the tractor and mower. Never mow an area in the reverse
direction that you have not inspected and removed debris or foreign material. (SGM-8)
WARNING!
Extreme care should be taken when operating near loose objects such
as gravel, rocks, wire, and other debris. Inspect the area before
mowing. Foreign objects should be removed from the site to prevent
machine damage and/or bodily injury or even death. Any objects that
cannot be removed must be clearly marked and carefully avoided by
the operator. Stop mowing immediately if blades strike a foreign
object. Repair all damage and make certain rotor or blade carrier is
balanced before resuming mowing. (SGM-5)
WARNING!
Mow only in conditions where you have clear visibility in daylight or with adequate artificial lighting.
Never mow in darkness or foggy conditions where you cannot clearly see at least 100 yards in front
and to the sides of the tractor and mower. Make sure that you can clearly see and identify passersby,
steep slopes, ditches, drop-offs, overhead obstructions, power lines, debris and foreign objects. If
you are unable to clearly see this type of items discontinue mowing. (SGM-1)
DANGER!
There are obvious and hidden potential hazards in the operation of this
Mower. REMEMBER! This machine is often operated in heavy brush
and in heavy weeds. The Blades of this Mower can throw objects if
shields are not properly installed and maintained. Serious injury or
even death may occur unless care is taken to insure the safety of the
operator, bystanders, or passersby in the area. Do not operate this
machine with anyone in the immediate area. Stop mowing if anyone
is within 100 yards of mower.
(SGM-2)
WARNING!
Do not mow with two machines in the same area except with Cab tractors with the windows closed.
(SGM-11)