Safety Section 1-8
SAFETY
RBF-19C 07-04
© 2004 Alamo Group Inc.
DANGER!
The center of Gravity of Tractors equipped with a Rear-Mounted Boom
Mower is shifted to the rear and removes weight from the front wheels.
Add front ballast until at least 20% of the tractors weight is on the front
wheels to prevent rearing up, loss of steering control, and possibly injury.
(SBM-10)
DANGER!
The Mower shaft speed must not - UNDER ANY CIRCUMSTANCES -
exceed 1800 RPM. (SBM-15)
WARNING!
Use extreme care and Safety Awareness when using the boom mower head to mulch loose brush
or wood that has fallen on the ground from overhead trimming. DO NOT mulch this debris if
bystanders, vehicles, livestock or buildings are within 300 feet of the mower. This cut debris can
be thrown at great velocities and could result in serious injury or even death. (SBM-17)
CAUTION!
Do not back up this implement when the boom or mower head is
extended. Backing could damage the machine or its components. (SBM-19)
WARNING!
Do not operate Mower if excessive vibration exists. Shut down PTO
and the Tractor engine. Inspect the Mower to determine the source
of the vibration. If Mower blades are missing or damaged replace
them immediately. Do not operate the mower until the blades have
been replaced and the Mower operates smoothly. Operating the
Mower with excessive vibration can result in component failure and
broken objects to be thrown outward at very high velocities. To reduce
the possibility of property damage, serious injury, or even death, never
allow the Mower to be operated with blades missing. (SFL-4)
Follow these guidelines to reduce the risk of equipment and grass fires
while operating, servicing, and repairing the Mower and Tractor:
-Equip the Tractor with a fire extinguisher in an accessible location.
-Do Not operate the Mower on a Tractor with an underframe exhaust.
-Do Not smoke or have an open flame near the Mower and Tractor.
-Do Not drive into burning debris or freshly burnt areas.
-Do Not attempt to mow or place the mower head close to burning debris.
-Never allow clippings or debris to collect near drivelines, gearboxes or
hydrualic componts such as valves, tanks, pumps and motors. Periodically
shut down the Tractor and Mower and clean clippings and collected debris
from the mower deck. (SBM-20)
WARNING!