Filter
Top Products
Assembly Section 2-9
ASSEMBLY
HUSCO VALVE PLUMBING (WITH MID-MOUNT VALVE)
The tractor ports used are on the selective control valve (SCV) and the Mid-Mount
valve. The SCV is located between the right arm of the three point hitch and the axle.
The Mid-Mount valve is located under the right front corner of the cab. The power
beyond port is located on the bottom of the Mid-Mount valve towards the front. The
excessive flow port is located on the underside of the SCV. The return port is
accessed through the end of a run tee located on the SCV. See the husco lift valve
page in the parts section for hardware and location of parts. Refer to the image
below as a guide.
SCV
MID-MOUNT VALVE
Use the existing adapter in the power beyond port on the mid-mount valve for the
pressure hose. That hose is routed to the “P” port of the priority valve. Next the
hose from the “CF” port on the priority valve goes to the “P” port on the danfoss lift
valve. The return hose from the lift valve is connected to the closest end on the run
tee of the “T” port on the selective control valve. Plumb the excessive flow hose
from the “EF” port on the priority valve to the “EF” port on the SCV. Then the load
sense hose goes from the “LS” port on the priority valve to the “LS” port on the lift
valve. Refer to the illustration below for port call-outs on the danfoss priority valve.
The return line on the mid-mount valve must be replaced with a hose. This hose is
routed from the existing adapter in the return port on the mid-mount valve to the run
tee in the “T” port on the selective control valve.