Tiger JD 5093E Lawn Mower User Manual


 
Assembly Section 2-7
ASSEMBLY
SWITCH BOX WIRING
Refer to the parts section for the Husco wiring schematic to hook up the switch
box. Cover all wires with plastic wire wrap provided. Route the green wires along
switch box bracket and cab frame to the steering wheel console. Route the rest of
the wires along the base of the right hand console and up to the rubber boot in the
bottom right corner in the rear window of the cab. The red and black wires will be
connected to the auxillary power plug in the back of the cab. After all wiring is
complete, secure all wires to the console with zip ties and push mounts. Take up
most of the slack so the wires are out of the way and tighten the zip-ties.
Remove the panel under the steering wheel to access the wires, locate the
brown wire and verify that this is the neutral safety wire with a test light or meter.
Then cut the brown wire and connect a green wire from the switch box to each end
of the brown wire as shown in the wiring diagram. Cut a small hole for the green
wires and the wire wrap to fit through and replace the console.
The red and black wires access power for the switchbox through a John Deere
auxillary power plug in the rear of the cab.
NOTE: The RED wire from the JD power plug should not be used because it
is ALWAYS “Hot”. +12 VOLTS ELECTRICAL POWER MUST BE TAKEN FROM
A SOURCE LOCATION WHERE IT IS LIVE ONLY WHEN THE IGNITION
SWITCH IS IN THE “ON” POSITION. THE RED WIRE MUST BE FUSED AT
THE SOURCE LOCATION WITH A CLOSED END CONNECTOR (# 34538).
Connect the red wire from the switch box to the orange wire from the JD power plug.
Connect the black wire from the switch box to the black wire from the JD power plug.
Two sets of wires have Metri-Pak ends on them. The white and black wires plug
into the brake valve. The orange and black wires plug into the travel lock.
Cut a cross hair pattern in the rubber boot in the right bottom corner of the rear
window. The wires can be routed through and the rubber falls back into position.
The hole should only be large enough for the wires to go through easily.
Route the Metri-Pak wires from the window boot to their location on the unit. Coil
the excess wire and secure it to the tractor frame with zip ties to eliminate vibration
and rubbing.
NOTE: When cutting or drilling a hole, be sure not to damage existing wires running
behind panels.