Filter
Top Products
Assembly Section 2-4
ASSEMBLY
DRIVESHAFT COUPLER - LOADER
To access the driveshaft of the JD-5101E, a hole will need to be cut in the front of
the tractor frame. After cutting a hole into the front casting the bottom edge of the
hole needs to be beveled out at a 45° angle with a grinder or file. Also the short end of
the coupler connects to the driveshaft and the longer end connects to the pump.
WHEEL SPACER WITH WHEEL WELL TANK
When the left wheel is off, a spacer kit is needed with the wheel well tank (part#
06200637.) Attach the spacer to the left wheel portion of the axle with the hardware
provided. When you are ready to re-attach the left wheel, the wheel goes on first
then the reinforcement ring and finally the hardware provided.