Filter
Top Products
Assembly Section 2-11
ASSEMBLY
The rubber boot in the corner of the rear window can be cut in a cross hair
pattern and if necessary the bottom cut through to allow it to slip over the cables and
back into position. These cables will be routed to the lift valve mounted on the valve
mounting plate, and should not have any sharp bends or kinks in them. Secure
cables with zip ties and apply RTV sealer or similar product in and around individual
cables, inside and outside of the cab for a water tight seal. Do not allow excess
cable to hang unsecured on the outside of the cab.
RUBBER BOOT
VALVE CABLES
ELECTRICAL WIRES
WINDOW ROUTING
CABLE CONTROL LEVER STAND
Place the cable control bracket on the floor so that the bracket is 2-1/2” from the
side edge of the door, and 4-3/8” in front of the rear edge of the door. See images below.
Be sure that the location of the stand will allow the operation of all control levers in the
tractor and that the door will not strike the stand when shut. Before drilling double check
location of the stand for proper placement of holes. Make sure that all cables and wires
are clear of the area before drilling holes to mount the stand. Drill 3 holes to match
control bracket as shown below and secure with capscrews and nylock nuts noted in
parts section.