Filter
Top Products
10 TASCAM CD-RW900MKII
1 − Introduction
Beware of condensation
If the unit (or a compact disc) is moved from a cold to a warm
place, or used after a sudden temperature change, there is a
danger of condensation; vapor in the air could condense on the
internal mechanism, making correct operation impossible. To
prevent this, or if this occurs, let the player sit for one or two
hours at the new room temperature before using.
•
Do not expose the infra-red receiver (light receptive
area on the front panel) to direct sunlight or intense light
for extended periods of time. Long exposure to this light
may result in failure of the remote control sensor.
•
When the remote control will not be used over one
month, please remove the batteries to prevent the possi-
bility of battery acid leakage which could damage the
unit. Should leakage occur, remove and discard the
batteries, and wipe the battery case thoroughly with a
cloth. Avoid getting the battery liquid on the skin. After
cleaning, replace with new batteries.
•
The remote control functions by using an infrared light
signal. When using the unit to control the CD-RW900MKII,
other devices that are turned on could be operated by its
signal.
•
If the range of remote operation becomes smaller, or
commands do not always function properly, the batter-
ies have become weak and should be replaced. Always
replace both batteries with new batteries of the same type.
•
Point the remote control to the remote sensor on the
main unit. Do not obstruct the path between the remote
control and the remote sensor.
Use of the remote control unit
Connections
The following should be noted when you connect the unit to
other equipment.
It is possible to connect the unit’s DIGITAL COAXIAL IN,
DIGITAL OPTICAL IN and ANALOG UNBALANCED INs (L,
R) to other equipment at the same time. However, the unit can
receive signals from only one digital input at a time.
Currently selected input jack is shown on the display.
Audio signals output from the unit are output from the analog
ANALOG OUT jacks, as well as from the DIGITAL COAXIAL
OUT jack and DIGITAL OPTICAL OUT connector simultane-
ously (but not from the digital outputs in stop mode).
If batteries are used improperly, or if leakage or breakage occurs,
the unit will not function.
Please observe the cautions indicated on the batteries and their
packaging to ensure proper usage.
•
Confirm + and – polarity and follow the indications
when inserting new batteries into the remote control.
•
Do not use old and new batteries together.
•
Even if the battery is the same size, the voltage may differ.
Do not use batteries of different specifications together.
•
Do not attempt to recharge batteries that are non-
rechargeable.
•
Do not open or disassemble batteries, throw them into a
fire or put them in water.
ª
Inserting batteries
1. Open the lid.
2. Confirm +/- polarity, and insert two AAA batteries.
3. Close the lid.
Batteries