Filter
Top Products
Assembly and Adjustments
Cutting Attachment Shield
Head Cap __
Screw
Bracket __-_-i
Outer
Tube
E4-$3000
Cutting
Attachment
Shield
Shim __
Nuts
I
Cutting
Attachment
Retaining Mounting Plate
Nut
Figure 9
Shim
Line Cutter
Figure 9A
Scre ws
Install the Cutting Attachment Shield E4-$3000
1. Insert the cutting attachment shield
between the outer tube and the cutting
attachment mounting plate. See Figure 9.
It may be necessary to loosen the retaining
nut and clamp screw to adjust cutting attach-
ment shield mounting plate.
2. Fit the two shims and the bracket over
the outer tube and loosely install the
four socket-head screws. See Figure 9.
3. Tighten the four socket-head cap screws
to secure the cutting attachment shield.
WARN|NG!
NEVER operate the unit without the
cutting attachment shield installed
and tightly secured!
CAUT|ON!
Make sure the clamp screw and re-
taining nut are securely tightened
before tightening the four socket-head
cap screws.
To Change Position of Line Cutter,
The line cutter can be positioned in 2
positions to obtain different line length for
cutting.
1. Remove the 2 hex screws with a 4mm
hex wrench. See Figure 9A.
2. Rotate line cutter. See Figure 9A.
3. Reinstall the two hex screws and
tighten them securely.
_IL WARN|NG!
The line cutter is very sharp. Wear
gloves to protect your hands when
handling.
Be careful to not lose the 2 nuts in the cutting
attachment shield, they are not captured.