Filter
Top Products
Product Description
Outer Tube
Cutting
Attachment Shield
E4-$3000 TRIMMER
Throttle Interlock
Fuel
Tank
Gear Case
Throttle
Trigger
Ignition Switch
Handle
Using the accompanying illustrations as
a guide, familiarize yourself with this unit
and its various components. See Figure 4.
Understanding your unit helps ensure top
performance, long service life, and safer
operation.
WARN|NG!
Do not make unauthorized modifica-
tions or alterations to any of these units
or their components,
Trimmer Head
Figure 4
Specifications E4-$3000
Dry weight (less attachments) ..................................... lb./5.0 kg
Engine model ....................................................................... SF2510E
Engine type ................................................... Power Boost Chamber
Bore x stroke ............................................... 1.3 x 1.1 in./34 x27 mm
Displacement ........................................................ 1.5 cu. in./24.5 cc
Maximum power ........................................................ 1.1 HP/0.8 kW
@ 7500 rpm (mill -1)
Fuel/oil ratio ............................... 50:1 with ISO-L-EGD or JASO FC
class 2-cycle mixing oil*
Carburetor type ................................. Walbro WYL, diaphragm-type
Fuel tank capacity ..................................................... 20.3 oz./600 ml
Ignition ............................................................. One-piece electronic,
program-controlled
Spark plug ..................................................................... NGK CMR5H
Air cleaner type ...................................... Non-reversible heavy-duty
filter element
Starting method ........................................................................ Recoil
Stopping method ............................................................. Slide switch
Transmission type .............................. Automatic, centrifugal clutch
w/bevel gear
EPA Emission Compliance Period** ............................ Category A
** The EPA emission compliance referred to on the emission compliance
label located on the engine, indicates the number of operating hours for
which the engine has been shown to meet Federal emission requirements.
Category C = 50 hours (Moderate), B = 125 hours (Intermediate) and A = 300
hours (Extended).
Specifications are subject to change without notice. Swisher E4 engine oil meets or exceeds these specifications
and is recommended for all Swisher products.
This unit comes fully assembled with the
exception of the cutting attachment shield
and cutting attachment.
Prior to Assembly
Before assembling, make sure you have all
the components required for a complete
unit and inspect unit and components for
any damage.
m
m
m
Engine and shaft assembly
Cutting attachment
Kit containing cutting attachment shield
mounting bracket and hardware, this
owner's/operator's manual and tool kit
for routine maintenance. Tool kits vary
by model and may include a hex wrench
set, a spark plug/screwdriver combina-
tion wrench, and a spanner.
The terms "left", "left-hand", and "LH";
"right", "right-hand", and "RH"; "front" and
"rear" refer to directions as viewed by the
operator during normal operation,