Filter
Top Products
Assemb|y and Adjustments
Handle
1. Position the handle on the outer tube as
shown. See Figure 3.
2. Install the mounting bracket with the
socket head cap screws. Tighten the
screws finger-tight ONLY at this time.
3. Ix)care the handle in the best position
for operator comfort (usually about 10
inches ahead of the throttle assembly).
4. Secure the handle by alternately tighten-
ing the four socket-head screws in a
diagonal or "criss-cross" fashion.
Socket-head Capscrews
Handle
Throttle Assembly
Figure 3
"" Outer Tube
ij
q
_ Mounting Bracket
Assembly and Adjustments
Adjust Throttle Lever Free Play E4-$3000
The throttle lever free play should be ap-
proximately 3/161/4 inch (4-6 mm). See
Figure 6. Make sure that the throttle lever
operates smoothly without binding. If it
becomes necessary to adjust the lever free
play, follow the procedures and illustra-
tions that follow.
Figure 6
3/16-1/4 inch (4-6 mm)
Throttle Free Play
Figure 7
1. Remove the air cleaner cover by loosen-
ing the two thumbscrews. See Figure 7.
2. Loosen the lock nut on the cable ad-
juster. See Figure 8.
3. Turn the cable adjuster in or out as
required to obtain proper free play
3/161/4 inch (4-6 mm). See Figure 8.
4. Tighten the locknut.
Figure 8
5. Reinstall the air cleaner cover.