Filter
Top Products
Spread out liner at the bottom of the pool. Excess material at the seams should be face down.
The bottom seam should lie well up on the earth mound. Drape liner over the wall so that it hangs evenly around
the outside of the pool. Make sure enough material is on the inside so the liner lies flat on the earth mound.
Secure liner to wall using plastic edging.
Excess material on side of liner should be distributed evenly around the entire pool. Excess material over hanging
the wall should be double folded as illustrated and should not be cut off.
Wrinkling of liner may be evident. This in no manner reduces any structural strength. You can now start filling the
pool with water.
On pool models equipped with a
porthole
Align the clear section of the liner with the
porthole cutout in the pool wall. The clear
section in the liner is oversized to allow for
easier alignment.
It is important that after the alignment, the
liner seam still lays flat on the Earth Mound
and is not suspended in the air. If the liner is
suspended at all, simply build up the Earth
Mound more in that location.
10 LINER INSTALLATION
CAUTION
YOUR POOL IS DESIGNED TO PROVIDE AN AMPLE SAFETY MARGIN WHEN IT STANDS ON LEVEL GROUND. FOR THIS PURPOSE A SLOPE IN EXCESS OF 2 INCHES
IN ANY DIRECTION WALL TO WALL IS CONSIDERED OFF LEVEL. YOUR POOL WARRANTY ONLY APPLIES TO POOLS INSTALLED ON LEVEL GROUND AS DEFINED
ABOVE.
ONCE YOU HAVE STARTED TO FILL THE POOL, DO NOT TRY TO PULL THE LINER FORCEFULLY. THE WEIGHT OF EVEN ONE INCH OF WATER WILL MAKE IT
IMPOSSIBLE TO MOVE THE LINER WITHOUT DAMAGING IT.
OUTSIDE VIEW OF POOL WALL
TOP RAIL
PLASTIC EDGING
VINYL LINER
POOL WALL
CORRECT INCORRECT
POOL LINER POOL LINER
AIR SPACE
POOL
WALL
EARTH
MOUND
EARTH
MOUND
POOL
WALL
8
Align clear section in liner with porthole