Filter
Top Products
If the through wall filter inlet and outlet holes
are to be used, remove metal cutouts by
breaking perforations using a knife and ham-
mer as shown. Refer to skimmer manufac-
turer's instructions for remainder of skimmer
assembly. Make sure skimmer does not
leak as this will corrode the pool wall and
cause a split in the wall that is not covered
under the pool warranty.
It is recommended to coat the exposed
metal on both sides with a clear lacquer or
nail polish to help resist rust and corrosion.
Pool models not equipped with
a porthole, proceed to step #10
The Porthole assembly must be placed
into the pool wall before installing the
liner.
As illustrated, place the Porthole Lens
inside the pool and position it so that its
four Snap Locks project through the
round hole in the pool wall.
Position the Porthole Trim Ring on the
outside of the pool so that its four Notches
align with the four Snap Locks projecting
from the Porthole Lens. Snap the Trim
Ring onto the Porthole Lens, making sure
that the four Snap Locks of the Lens lock
securely into the four Notches of the Trim
Ring.
8 THRU-THE-WALL SKIMMER
7
9 PORTHOLE INSTALLATION
Porthole lens
Snap locks
Outside of pool
Notches
Hole in pool wall
Trim ring