Stanley Black & Decker GTR20 Portable Generator User Manual


 
GTR20 User Manual ◄ 11
Figure 2. Hydraulic Connections
from the male to the female quick disconnect as shown
in gure 2. Quick disconnect couplings and hose ttings
are selected so that additional ttings such as reducer or
adapter ttings are not required.
If adapter ttings are used, they must be approved steel
hydraulic ttings meeting a minimum operating pressure
rating of 2500 psi/172 bar. Do not use galvanized pipe
ttings or black pipe ttings.
Use thread tape or pipe joint compound when installing
quick disconnect couplings to hose or tool ttings. Fol-
low the instructions furnished with the selected thread
sealant. DO NOT OVERTIGHTEN THE FITTINGS.
6. BATTERY
The supplied 12 Volt DC battery is a non-spillable, main-
tenance-free battery and is fully charged.
Make sure the battery cables are tight and charging cir-
cuit functions are operating properly.
Do not charge the battery with a standard auto-
motive battery charger. This type of charger pro-
duces a charging amperage higher than 2 amps.
Charging the battery at higher than 2 amps will
damage the battery.
NOTICE
NOTICE
If the engine runs out of gas or dies during op-
eration and the ignition switch is left in the ON or
RUN position, this could drain the battery. Make
sure the ignition switch is returned to the OFF
position.
VALVE BLOCK
PRESSURE
PRESSURE
PRESSURE
RETURN
PRESSURE
RETURN
Adapter, 1/2 inch Male Pipe x
-10 SAE O-Ring (P/N 07882)
HTMA, 1/2 inch Male Quick
Disconnect Coupler (P/N
24061, Coupler Body or
P/N 03974, Coupler Set)
HTMA, 1/2 inch Female Quick
Disconnect Coupler (P/N
24060, Coupler Body or
P/N 03974, Coupler Set)
1/2 inch. ID Hose, 25 ft to 50
ft long.
(25 ft: P/N 04972 or P/N
05009, Dual Hydraulic Hose)
(50 ft: P/N 04978 or P/N
05008, Dual Hydraulic Hose)
1/2 inch Male Pipe Hose End
HTMA, 1/2 inch Male Quick
Disconnect Coupler (P/N
24061, Coupler Body or
P/N 03974, Coupler Set)
HTMA, 1/2 inch Female Quick
Disconnect Coupler (P/N
24060, Coupler Body or
P/N 03974, Coupler Set)
Adapter, 3/8 inch Male Pipe x
-8 SAE O-Ring (P/N 00936)
OPERATION