Filter
Top Products
18 www.ferrisindustries.com
Installation
Blower Installation
3" - 3-3/8"
(7,6 - 8,6 cm)
3. Check the belt tension by measuring the distance
from the center of the v-idler pulley (A, Figure 29)
mounting bolt and the blower housing. This
should measure between 3 - 3-3/8” (7,6 - 8,6 cm).
4. If measurement falls outside of this range, you
must move the idler pulley (B) either forward or
back to achieve the proper belt tension.
NOTE: If pulley position needs to be adjusted, make
sure that it is reinstalled in the same row of holes as
determined in the blower assembly (Step 13, page
11).
Figure 29. Check Belt Tension
A. V-Idler Pulley
B. Idler Pulley
B
A
A
B
C
C
Figure 30. Install Guards
A. Blower Belt Guard
B. Deck Guard Top
C. Knob
5. Install the blower belt guard (A, Figure 30) and
secure with the flange head bolts previously
removed.
6. Install the deck guard top (B) and secure with the
supplied knobs (C).