Filter
Top Products
29
Adjustments/Service
Figure 27. Shear Pins
A. Shear Pins
B. Cotter Pins
A
B
SHEAR PIN REPLACEMENT
Under most circumstances, if the auger strikes an
object which could cause damage to the unit, the
shear pin will break. (This protects the gear box and
other parts from damage.)
The shear pins are located on the auger shaft as
shown in Figure 27. To replace the shear pins, tap
out the broken pin with a pin punch, and install a new
shear pin and cotter pin. Do NOT replace shear pins
with anything other than the correct grade
replacement shear pin. (Use of bolts, screws or a
harder shear pin will lead to damaged equipment.)
WARNING
Do not go near the discharge chute or auger
when the engine is running. Do not run the
engine with any cover or guard removed.
Figure 28. Belt Guide
A. Idler Pulley (Engaged Position)
B. Belt Guide
C. Capscrew
D. Belt
A
1/8” (3.18mm)
C
B
BELT GUIDE ADJUSTMENT
1. Disconnect spark plug wire.
2. Remove screws (B, Figure 25) from belt cover (A).
Remove belt cover (A).
3. Measure the distance between the belt guide (B,
Figure 28) and the belt (D). The distance should
be 1/8 inch (3.18mm).
4. If adjustment is necessary, loosen belt guide
capscrew (C). Move belt guide (B) to correct
position. Tighten capscrew (C).
5. Reinstall belt cover (A, Figure 25) securing with
screws (B).
6. Reconnect spark plug wire.
D
Service
A
B