Filter
Top Products
STEP 5: Install the bag adapter (42” Deck):
a. Remove the wing nuts, split lock washers, flat washers,
and hex nuts that secure the deflector to the deck, and
remove the deflector. See Figure 8.
b. Fit the two top holes in the adapter over the wing nut
studs. Secure the adapter with the flat washers, split lock
washers and wing nuts removed in Step 5a. Tighten
securely. See Figure 9.
STEP 6: Install the grass catcher support:
a. Remove the three noted bolts and nuts from the right rear
of the unit. See Figure 10.
b. Install the catcher support onto the unit, securing with the
hardware noted in Figure 11. Tighten all hardware securely.
NOTE: Be sure to reinstall any components that may have
been removed when removing the hardware in Step 6a.
STEP 7: Insert the bagger channel into the grass catcher
support, and secure with two 1/2 x 4-3/16” clevis pins,
washers, and hair pins. See Figure 12.
3
FIGURE 8
REMOVE
DEFLECTOR
FIGURE 9
INSTALL
ADAPTER
INSTALL
WASHERS
AND WING
NUTS
FIGURE 11
SECURE WITH
REMOVED
HARDWARE
SECURE WITH
SUPPLIED 5/16
x 3/4” HEX
WASHER HEAD
BOLT & FLANGE
LOCK NUT
SECURE WITH
SUPPLIED 5/16
x 3/4” HEX
WASHER
HEAD BOLT
FIGURE 12
INSERT CHANNEL
INTO CATCHER
SUPPORT
CATCHER
SUPPORT
(SHOWN
DETACHED
FROM UNIT)
WASHER &
HAIR PIN (2)
CLEVIS PIN (2)
REMOVE
NUTS AND
WASHERS
FIGURE 10
REMOVE
HARDWARE