Filter
Top Products
30
www.SnapperPro.com
Figure 28. 2 x 4 Locations
A. 2 x 4 Blocks
B. Arrow Indicating the Front of the Machine
Deck Leveling Adjustment
S/N: 2014523387 & Below
1. Park the machine on a flat, level surface. Disengage
the PTO, stop the engine and engage the parking brake.
Rear tires must be inflated to 15 psi (1,03 bar).
2. Pull the cutting height adjustment handle (A, Figure 27)
up and out of the handle lock position (B) and adjust the
deck to the 3” (7,6 cm) position.
3. Repeat process for other side of machine.
NOTE: Both sides of the deck must be adjusted to the same
height.
4. Place 2 x 4 blocks under the rear of the mower deck
with the 3-1/2” sides being vertical. See Figure 28.
5. Loosen the deck leveling hardware (D, Figure 27) on
both sides of the machine.
6. Make sure that the rear of the deck is resting on the 2 x
4’s. Tighten the deck leveling hardware on both sides of
the machine.
7. Remove all 2 x 4 blocks from under the mower deck.
Figure 27. Deck Leveling Adjustment
A. Cutter Height Adjustment Handle
B. Handle Lock Position
C. Cutting Height Indicator
D. Deck Leveling Hardware
C
B
A
D
B
A
Regular Maintenance
Not for
Reproduction