Filter
Top Products
30
www.snapper.com
Engine Maintenance
Refer to engine owner’s manual for all engine maintenance
procedures and recommendations.
Adding Fuel
To add fuel:
1. Stop the engine and allow to cool for at least 3 minutes.
2. Remove the fuel cap (see A, Figure 31).
3. Fill the tank to the bottom of the filler neck. This will
allow for fuel expansion.
NOTE: Do not overfill. Refer to your engine manual for
specific fuel recommendations.
4. Install and hand tighten the fuel cap.
Fuel Filter
The fuel filter is located in the fuel line between the fuel tank
and fuel pump. If the filter is dirty or clogged, replace as
follows:
1. Disconnect the negative battery cable.
2. Place a container below the filter to catch spilled fuel.
3. Using pliers, open and slide the hose clamps from the
fuel filter (C, Figure 31).
4. Remove the hoses from the filter.
5. Install the new filter in the proper flow direction in the
fuel line.
6. Secure with the hose clamps.
7. Reconnect the negative battery cable when finished.
WARNING
Gasoline is highly flammable and must be handled
with care. Never fill the tank when the engine is still
hot from recent operation. Do not allow open flame,
smoking or matches in the area. Avoid over-filling and
wipe up any spills.
Do not remove fuel filter when engine is hot, as spilled
gasoline may ignite. DO NOT spread hose clamps
further than necessary. Ensure clamps grip hoses
firmly over filter after installation.
Do not use gasoline containing METHANOL,
gasohol containing more than 10% ethanol,
gasoline additives, premium gasoline, or white
gas because engine/fuel system damage could
result.
Figure 31. Maintenance
A. Fuel Tank Cap
B. Transmission Oil Caps
C. Fuel Filter
A
B
C