Filter
Top Products
8
SECTION 1 – ASSEMBLY INSTRUCTIONS
B. Remove Hinge nut, Spring, and Hinge Pin. Remove
Deflector. Save for future use. See Figure 1.12.
FIGURE 1.12
C. Hold the Adapter in front of the deck. Align the
Adapter Lugs with the Lug Retainers in the Hinge.
Push or lightly tap front of Adapter towards the rear
until tight against deck. See Figure 1.13.
FIGURE 1.13
D. Install one of the previously removed bolts into the
hole in the center of the discharge opening and
through the hole in the Adapter. Secure the Adapter
to the deck with a flat washer and wing nut. See
Figure 1.14.
FIGURE 1.14
D. Attach Tube Latch to Adapter. Insert one 1/4-20 x
3/4” Carriage bolt from inside through upper hole in
Adapter. Place Tube Latch over bolt, followed by
1/4” Internal Tooth lock washer and secure with
1/4-20 hex nut. Align Tube Latch as shown and
tighten securely. See Figure 1.15.
FIGURE 1.15
STEP 9
GRASS TUBE INSTALLATION
A. Attach Tube Handle and Handle Base to Tube
before installing Tube to catcher. Insert (2) 1/4-20 x
3/4” Carriage bolts through Handle Base and holes
in Tube as shown. See Figure 1.16. Place Tube
Handle over bolts followed by 1/4” Internal Tooth
lock washers and secure with (2) 1/4-20 hex nuts.
Tighten securely.
HINGE PIN
SPRING
HINGE NUT
LUG RETAINERS
ADAPTER LUGS
ADAPTER
WING NUT &
FLAT WASHER
TUBE LATCH