Filter
Top Products
Step 8: See Figure 8:
Figure 8
Install the Doors for frame / door alignment.
A. Follow the instructions in the Door Hardware
Package to install the Door Bottoms and the
Door Latches.
B. Install, close and latch both Doors.
C. Tighten all bolts from previous steps at this
time. Add two 5/16” nuts to the Front Panel
Frame leg bolts at reference A. Tighten
securely.
Note: If door latch rod does not line up with
notch in latch plate loosen the Foot clamp and
move Foot forward or rearward to raise or lower
the rod. Tighten the clamp.
D. Remove the Doors to complete the
installation.
A
Step 9: See Figure 9:
Install Windshield (17) and Front Panel Vinyl
(16).
17
A. Place the Windshield and Front Panel Vinyl
face up on a clean flat surface. Press the hook
and loop fastener together.
16
B. Lay the rod sewn into the top of the
windshield over the top frame. Close the snap
flaps around the corners of the top frame.
C. Secure the ties to the cross bar and close
the snap flaps around the posts.
D. Lock the brake pedal down. Fit the vinyl
around the Foot Pocket Guards and Pedals.
Connect the hook and loop fastener under the
step plates .
Figure 9
9