Filter
Top Products
Step 4; See Figure 4:
Install right & left Front Posts (5) and right & left
Top Frame Braces (6 & 7).
Note: Bent ends of Top Frame Braces will point
rearwards and lay flat when properly installed.
6
5
7
A. Insert a 1/4” x 3/4” bolt forward through the
tab on the post, the end of the Front Panel
Frame and then the lower end of the Top Frame
Brace. Add a nut. Tighten just enough to hold
the braces up.
B. Insert a 1/4” x 3/4” bolt outwards through the
lower hole in the foot, the lower hole in the post
and then the right Foot Pocket Guard (shorter
than left). Add a nut. Tighten enough to hold
the Foot Pocket guard as shown.
C. Insert a bolt out through the upper hole in
the Foot and Post. Place a door hinge from the
Door Hardware Package over the bolt and add
a nut. Do not tighten at this time.
D. Repeat on left side of tractor.
Figure 4
Figure 5
Step 5; See Figure 5:
Install Rear Cross Bar Brackets (8) and Rear
Cross Bar (9)
B
A. Remove the bolts at Reference B.
B. Place the Rear Cross Bar Brackets over the
holes as shown. Replace the bolts. Do not
tighten at this time.
8
C. Place the tabs welded to the Rear Cross Bar
over the brackets as shown. Insert two bolts
down through the holes and add locknuts. Do
not tighten at this time.
9
7