Filter
Top Products
Chapter 4
Using the remote control
Your SMART Table includes a remote control for the projector. SMART Technologies
configures the projector for your SMART Table. Therefore, you only need to use the
remote control in the following situations:
• Setting the projector for high altitude use
• Resetting the projector lamp time after replacing the projector lamp
• Starting the projector after a power failure (see Troubleshooting tips on page 17)
CAUTION
SMART Technologies recommends that you only use the remote control to
complete the procedures documented in this chapter. Using the remote control for
other purposes may change the projector’s settings, which were specifically
configured for the SMART Table.
NOTE
The projector’s receiver is located at the bottom of the projector. If you need to
use the remote control to make changes on the projector’s menu, open the door
and point the remote towards the bottom of the projector.
Locating the remote control
The remote control is located inside of the cabinet behind the metal bar. Return it to
the same location when you’re finished using it.
Remote
control