Filter
Top Products
4 | CHAPTER 1 – OVERVIEW
Power cable
The power cable provided with your SMART Table is
specific to your region and should work with outlets in
your school.
Connect the power cable to the SMART Table following the instructions in the SMART
Table 230i textless installation instructions (smarttech.com/kb/141081)
.
If you must extend the power cable across the floor, ensure it’s properly marked to
prevent a trip hazard. SMART Technologies recommends that you connect the power
cable to a power bar rather than directly to an outlet. Contact SMART Technical
Support for a replacement.
Keys
The keys allow you to lock the cabinet to prevent unwanted access to
the computer and projector. Store the keys in a convenient, safe
location.
Projector remote control
The projector remote control is stored on the inside of the cabinet. You don’t need the
remote control while using the table, but SMART recommends that you keep it inside
the cabinet so you can easily locate it when you need to turn the projector on or off or
to adjust the projector’s settings while servicing the table.
Installation instructions
Follow the SMART Table 230i textless installation instructions (smarttech.com/kb/
141081) to unpack and set up your SMART Table.
Warranty information
Retain the warranty information in case an issue occurs with your SMART Table
during the warranty period.
Uninterruptible power supply (UPS)
The UPS provides power to the computer when power fails or if the power cable is
disconnected during table operation. The UPS generates an audible alarm and
signals the computer to shut down safely to protect the computer’s operating system
from damage.