Filter
Top Products
19
Starting the Engine
1. While sitting in the operator’s seat, engage the parking
brake and make sure the PTO switch is disengaged and
the motion control handles are locked in the NEUTRAL
position.
2. NOTE: A warm engine may not require choking.
Set the engine throttle control to FAST throttle position.
Then fully close the choke by pulling the knob OUT fully.
3. Insert the key into the ignition switch and turn it to
START.
4. After the engine starts, gradually open the choke (push
knob down fully). Reduce to half throttle speed and
allow to warm up.
Warm up the engine by running it for at least a minute
before engaging the PTO switch or driving the rider.
5. After warming the engine, ALWAYS operate the unit at
FULL THROTTLE when mowing.
In the event of an emergency the engine can be stopped
by simply turning the ignition switch to STOP. Use this
method only in emergency situations. For normal engine
shut down follow the procedure given in Stopping the Rider.
Operation
Stopping the Rider
1. Returning the ground speed control levers to the middle
position will stop rider movement. Pivot the levers
outward and lock them in NEUTRAL.
2. Disengage the PTO by pushing down on the PTO switch.
3. Engage the parking brake by pulling the handle up until
it locks into position.
4. Move the throttle control to mid-throttle position and
turn the ignition key to OFF. Remove the key.
WARNING
Read the Operator’s Manual before
attempting to operate the machine.
If you do not understand how a specific control •
functions, or have not yet thoroughly read the FEATURES
and CONTROLS section, do so now.
Do NOT attempt to operate the tractor without first •
becoming familiar with the location and function of ALL
controls.