Filter
Top Products
SNOWTHROWER REMOVAL
Refer to figures 6-10 on pages 8-10 for removal proce-
dures.
1. Park tractor on hard level surface.
2. Lower snowthrower attachment to ground.
3. Stop engine, lock parking brake, and remove key.
4. Pull coupler (A, figure 9) on snowthrower PTO shaft
and disconnect from tractor’s PTO shaft.
5. Remove PTO support rod (C, figure 6) from retaining
hook (D) and support PTO driveshaft (A).
6. See figure 10. Remove large ring pin C) securing
bottom half of handcrank from spiral spring shaft (B)
and remove handcrank.
7. Remove small ring pin holding upper half of
handcrank in bracket and remove handcrank.
Note:
Chute Rotator Bracket (refer to figure 2, page 6)
can be left installed or removed for operation of other
attachments.
8. Pull out shot pins (A, figure 7) on rear of snowthrower
and turn until roll pin fits in groove. Repeat for other
side.
9. Start tractor, lower hitch, and slowly backaway from
snowthrower.
Note: Leave PTO driveshaft mounied on snowthrower
suppotied
by PTO support rod.
IO. Store snowthrower with PTO, handcrank and chute
rotator bracket (if removed).
HITCH REMOVAL
Refer to figure 3, page 7 and figure 5, page 8 for hitch
removal procedures.
1. Park tractor on hard level surface.
2. Stop engine, lock parking brake, and remove key.
3. Remove spring clip and clevis pin (E, figure 5) secur-
ing lift rod front clevis to hitch lift arm.
4. See figure 3. Remove spring clip (E) and clevis pin
(D), securing lift rod rear clevis (B) to tractor lift lever
(F). Remove lift rod (A).
5. See figure 5. Remove left and right spring clips (D)
and clevis pins (C) securing attaching links to tractor
hitch.
6. See figure 5. Raise hitch and pull foward to remove
hitch pins (A) from tractor hitch brackets(B).
7. Remove and store hitch with lift arm and attaching
hardware.
USING SNOWTHROWER
I
A
CAUTION
I
Start
snowthrower
with engine running slowly to
prevent damage to snowthrower and tractor.
1. Run engine at one quarter throttle.
2. Engage PTO switch to start snowthrower.
3. Run engine at full throttle.
4. Lower snowthrower to ground and slowly drive into
area to be cleared.
A
CAUTION
When operating snowthrower, do not use down-
ward pressure, in order to avoid damage to cutting
edge and snowthrower.
5. Disengage PTO switch to stop snowthrower.
A
WARNING
If any object is picked up and/or thrown, other than
snow, stop snowthrower and tractor (stop engine,
lock parking brake and remove key) immediately
and inspect for damage.
12