Filter
Top Products
5
Normal Installation &
Removal
INSTALLATION & REMOVAL
NOTE: For first-time installation, refer to Initial Setup &
Installation.
NOTE: If mower deck is equipped with Mulching Kit, the
mulching baffles must be removed for grass collection.
Make sure the high-lift blades (34') or high-lift tabs (30')
are installed per the Assembly Instructions at the back of
this manual.
1. Install the grass bag and bracket assembly (A, figure
1) on the anchor assemblies (B) located on each side
of the transmission housing. Push forward so the
bracket assembly rests fully on the anchors.
2. Insert the round pin (C) through the bracket assembly
and frame, and secure it using the safety clip pin (D).
NOTE: If grass bag and bracket assembly is too bulky to
install as one piece, separate the grass bag cover (A, fig-
ure 2) from the upright support (B) by removing clips (D)
and long clevis pins (C). Reinstall cover after support
assembly is properly installed.