Filter
Top Products
12
Initial Setup - All Models
FRAME & BAGGER SUPPORT
ASSEMBLY - ALL MODELS
Note: Units with 0510 transmissions use anchors (A, fig-
ure 13) with a notch, all other units use anchor with no
notch. See Inset Figure 13.
1. Assemble the two anchors (A, figure 13) to the trans-
mission housing using the 5/16-18 x 3 capscrews (B),
washers (C) and nuts (E). Install the capscrews from
the bottom of transmission. Do not tighten hardware
at this time.
2. Position support assembly (F, figure 13) on anchors
and secure to rider with safety clip pin (G) and round
pin (D).
3. Fully seat each anchor into the support assembly
tubes and square up bagger frame with rider frame.
Tighten anchor mounting hardware securely.
4. Place catcher support (H) into support assembly as
shown (figure 13).
Figure 13.
A. Anchor
B. Capscrew, 5/16-18 x 3
C. Flat Washer, 5/16
D. Round Pin
E. Nut, Flange Lock, 5/16
F. Support Assembly
G. Safety Clip Pin
H. Catcher Support
C
A
B
D
E
G
F
H
All Other
Models
(No Notch)
0510 Transmssion
Models
(Notch)