Filter
Top Products
13
Initial Setup - All Models
GRASS CATCHER ASSEMBLY -
ALL MODELS
NOTE: Cover and bag support are packaged as an
assembly with long clevis pins and clips. It may be easier
to separate components for the following step.
1. Install horizontal bag support (A, figure 14) to upright
catcher support (B) holes as shown. Note that the
open set of holes (D) is toward the discharge side of
mower. Install four 3/8-16 x 7/8 capscrews (C) from
the front and lightly secure with flange lock nuts.
2. Make sure bag support and catcher support are
square, then tighten flange lock nuts.
3. Reinstall grass catcher cover (A, figure 15) to support
(B) and secure with clevis pins (C) and clips (D).
4. Install handle (A, figure 16) to rear surface of lid with
offset toward the rear. Secure with two 10-32 x 1/2
truss screws (B) and 10-32 hex nuts (C).
Figure 14.
A. Bag Support C. Capscrew, 5/16-18 x 7/8
B. Catcher Support D. Open Set Of Holes
Figure 15.
A. Cover C. Clevis Pin
B. Support D. Clip
Figure 16.
A. Handle
B. Truss Screw
C. Hex Nut, 10-32