Filter
Top Products
9
A
B
C
1. If installed remove nylon line head, adapter plate, shield plate, and plastic
shield:
a. Align locking hole in adapter plate with notch in edge of gear housing and
insert head locking tool (A).
b. Remove line head (B) by turning it clockwise until head is completely off of
shaft.
c. Remove locking tool.
C
J
I
d. Remove three screws holding shield plate (E) and plastic shield (C) to gear
housing.
e. Retain line head (B), adapter plate (D), shield plate, and plastic shield
(C).
2. Loosely attach bracket (I) to shield (J) and attach shield to bottom of gear
housing (F) with hardware provided.
3. Tighten all shield hardware.
F
Assembly (continued)
E
D