Filter
Top Products
8
Assembly
Throttle Linkage and Ignition Leads All Models
Ground Wire
Terminal
Ground
Wire
Assemble and Adjust
the Throttle Cable.
1. Insert the throttle-cable housing into the
notch on the fan cover, and clamp the
ground wire terminal between the fan
cover and the outer cable adjuster nut.
See Figure 13.
2. Tighten the two throttle cable adjuster
nuts.
IMPORTANT!
Adjust and tighten the cable nuts to allow
approximately 1/4-inch free play at the
throttle trigger.
CAUTION!
Routing of wiring must not interfere with
throttle operation.
Figure 13
Reinstall the Spark
Plug Cap
Black Ignition
Wire
Red Wire
Cable Adjuster
Nuts
3. Using finger pressure only, connect
the black ignition wire from the cable
tube to the red ignition wire on the
powerhead. Wire routing must be as
shown in the illustration with the black
wire located away from the throttle cable
and carburetor linkage.
4. Reinstall the engine cover and tighten
the captive engine cover screw.
5. Reinstall the spark plug boot.